PowerSeries Neo/PowerSeries Pro Local Firmware Upgrade

From DLS5 Wiki
Revision as of 22:06, 25 May 2015 by Jvankooten (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

1. In the DLS 5 Software, go to Tools and Select Flash Wizard

NeoLocalFirmware-1.png


2. The Flash Wizard will open and give you a selection where you can choose COM Port, and select the file to be uploaded (Browse to a local file, or click Web to search on the DSC flash file FTP

NeoLocalFirmware-2.png


3. If you open the Web section, you will see the different firmware files available on the FTP

4. Double-click or press [ENTER] to select the file you would like to load

NeoLocalFirmware-3.png


5. After continuing, the Flash Wizard will show the current panel version details

6. Click Next to continue with the upgrade if these are correct

NeoLocalFirmware-4.png


7. For the upgrade to continue, please make sure the PC-Link cable is correctly connected to the left-hand 4 pins on PC-Link 2

8. Option 5 must be enabled in section [382]

9. Option 7 must be enabled in section [401]

NeoLocalFirmware-5.png


10. Appropriate connection for the upgrade is shown below

11. The PC-Link cable must be connected on PC-Link 2, and must be on the left 4 pins.

12. The circuit board of the PC-Link connector must face down toward the terminal strip, with the jack facing up

NeoLocalFirmware-6.png


13. After continuing, you will see the current panel info, and the upgrade panel info

14. Click Next to start the firmware flash to the new version

NeoLocalFirmware-7.png


15. The firmware will start being sent to the panel, with a progress bar status. The Next button will remained grayed out until the transfer is complete

NeoLocalFirmware-8.png


16. Once the firmware has been sent to the device, the screen will change to show that the update is being loaded to the panel

NeoLocalFirmware-9.png


17. After the firmware is sent, DLS will verify the flash file of the unit to make sure that it is showing the correct information

NeoLocalFirmware-10.png


18. Once DLS verifies the firmware, it will show you a final screen with the new version information

19. From this point, you can click Finish if you are done with the upgrade, or Back to flash another unit/firmware. If you have loaded the panel firmware, you will now need to load the firmware bundle containing files for the HS2#### keypads and HSM2HOST

NeoLocalFirmware-11.png


Please Note: If your panel does not normally have a 3G2080/TL2803GR/TL280 on it, please remember to disable [382] opt 5 and [401] opt 7 to ensure you do not have a trouble on the panel after leaving the site

Retrieved from "https://dlshelp.dsc.com/index.php?title=PowerSeries_Neo/PowerSeries_Pro_Local_Firmware_Upgrade&oldid=2482"